In order to support MSD contactless NFC transactions with the older version of the Vx805 (8.42B) and triPOS 5.17.0 the triPOS.EMV.config located on this page must be used.
After installing triPOS 5.17/5.18 follow the instructions below to replace the triPOS.EMV.config
Hi Tom,
This is not needed to enable MSD Contactless on Vx805's with cXPI 12.31.11 and is only needed for the older XPI 8.42b version.
The one sheet (EMV Contactless Worldpay IP Action Plan UPDATES 04012020.pdf) states that Vx805's with 12.11.31 and triPOS direct
"With triPOS Version 5.17 and earlier, the contactless functionality may be disabled."
Does this mean the configuration within triPOS changes "accept contactless payments" to "no"?
Under the "Card Brand EMV Contactless Compliance Requirements" "...retire the use of legacy (MSD) contactless..." the message leads me to believe its fully disabled for the Vx805's.
TL;DR - Is the reason this fix is not needed for 12.31.11 because contactless with MSD is disabled all together?
I appreciate the help and the quick response!
Hi Tom,
I believe this note was intended to indicate that once EMV Contactless is enabled then MSD Contactless will be disabled as is required by compliance.
I will work on updating this document to provide better clarity.
Apologies for any confusion.
Thanks,
~Jerry
Hi Jerry,
Appreciate the follow-up and no worries. I'm limited in my capacity to personally test at the moment, apologies for needing further clarification.
Can the Vx805 with 12.31.11 on 5.17 process MSD contactless payments?
Thanks,
Tom
Hi Tom,
MSD contactless payments are available with Vx805 Cxpi (12.31.11).
There is an open issue in regards to MasterCard and MSD contactless.
Our triPOS development team is actively working VeriFone to resolve however I do not have an ETA for resolution at this time.
Thanks,
~Jerry
Will this work for enabling MSD Contactless on Vx805's with cXPI 12.31.11?